During the winter, when temperatures drop, you might be tempted to turn on the heat, but that won’t stop the furnace from being noisy. If you’re not sure what’s causing the noise, check to see that the thermostat is set to heat, and the fuse or circuit breaker is on. If the furnace won’t turn on, the problem might be with the electrical panel or with the blower motor. To fix this issue, you can flip the breaker off and replace the fuse or circuit breaker. However, if the problem persists, you’ll need to call an electrical contractor to repair the electrical system.
To diagnose the problem yourself, turn the thermostat down a few degrees and check again after a few minutes. If the temperature is still too low, it may be a problem with the temperature distribution. If there are cold spots in the house, the heating system is working too hard. If you ignore them, you’ll be raising your heating bill. If this is the case, it’s time to call a professional. If you have a thermostat problem, you can start by performing a basic maintenance check.
Another common furnace problem is the pilot light. Some pilot lights have a screw to adjust the flame. To fix this, turn off the power and turn off the gas. If the plug is still on, check the air intake vent. In some cases, a blocked air intake pipe can cause a problem with the furnace. If you suspect this to be the issue, you can clear the air intake vent to ensure that it’s functioning correctly.
The air intake vent may be plugged or blocked. Either way, a blocked air intake vent can lead to malfunctioning furnaces. Make sure the air intake vent is free of debris. In addition, check the ducts and vents for cracks and leaks. Then, the air intake duct may need cleaning. You can call a technician to check and repair these issues. A faulty thermostat can result in sky-high heating bills and uncomfortable indoor air quality.
To diagnose and repair a malfunctioning thermostat, check the air intake vent and clean it of debris. If the thermostat is working properly, it’s important to clean the air filter and the air intake pipe to ensure proper ventilation. If the filters are dirty, the furnace will be hotter than it should be. If it isn’t, you can contact a professional for furnace repair. These services are also affordable and can solve the problem for you.
When a furnace is malfunctioning, you need to turn it off and wait until a technician arrives. You’ll need a professional to diagnose and repair your furnace and make recommendations. During the winter, your heater should be set to “heat” and not “cool” unless it’s already malfunctioning. Otherwise, you can call a professional to perform a routine furnace service. If it’s not, you should check the air filter, the ducts, and the thermostat.